Get A Quote

 

Everyone maintains their own idea on the subject of How to Troubleshoot and Repair an Electric Water Heater.

Numerous contemporary homes make use of an electric water heater for their furnace, due to its ease and also convenience of use. Nevertheless, similar to any other electrical devices, problems may emerge with its usage, suddenly. It can be actually frustrating to get up to a cool shower rather than a hot one or having your bathroom with water that isn't warm adequate or even too hot. Whatever the case might be, hot water heater problems can be fairly aggravating. Fortunately, we have actually made a checklist of feasible remedies to your hot water heater concerns. There are a variety of variables that can cause much of these problems, it could be a problem with the power supply, the electric burner, or the thermostat. Prior to doing anything, guarantee you switch off the major power supply for safety and security. Whatever the trouble is, getting it dealt with need to not posture way too much of a concern if you comply with these steps:

 

Check Your Power Supply:

As standard as this might seem, it is very essential. Without ample power, your water heater will not operate. So the first thing to do when your water instantly stops working is to validate that it isn't a power issue. Inspect if the fuse is blown out or the breaker tripped. If the breaker is the problem, simply transform it on and off once again. Change any damaged or worn-out fuse. Evaluate the device with power after these changes to see if it's currently functioning.

 

Check the Heating Element in the Hot Water Heater:

If it's not a power trouble, then attempt having a look at your burner if it is still functioning. Check each of your heating elements to be sure the issue isn't with any one of them. If any of them is damaged, replace that part and afterwards examine whether the hot water is back on.

 

Examine Your Thermostat:

If your water heater still isn't functioning or the water appearing isn't warm sufficient, you might require to examine the temperature level setups on your top thermostat. Ensure the circuit breaker is turned off before doing anything. Open the access panel and also press the red switch for temperature reset over the thermostat. This need to assist heat the water. Transform the circuit breaker back on and examine if the issue has actually been settled.

 

Call An Expert:

If after replacing all malfunctioning parts as well as resetting your temperature, the hot water heater still isn't working, you may require to get in touch with a specialist plumber for a professional viewpoint. The trouble with your heating unit could be that the cold and hot faucets have been changed or it might be undersized for the quantity of warm water needed in your home. Whatever the situation might be, an expert plumber would assist solve the problem.

 

Conclusion

Hot water heater issues are not constantly major. A lot of them result from minor problems like a blown fuse or worn-out burner. Replacing the malfunctioning parts must do the trick. However, if you are still not able to solve the trouble, give a call to your closest plumber to find to get it dealt with.

 

8 possible reasons why you have no Hot Water

 

Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.

 

Water Leak

 

Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.

Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.

 

Gas Heater: Gas Leak

 

If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.

 

Gas Heater: Pilot Light Problems

 

There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.

Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.

 

Gas Heater: Faulty Thermocouple

 

The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.

 

Electric Heater: Breaker Blues

 

Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.

 

Electric Heater: Reaching The Limit

 

If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.

 

Electric Heater: Heating Element

 

If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/

 

I am just very excited about How to Troubleshoot and Repair an Electric Water Heater and I am praying you enjoyed the article. Are you aware of somebody else who is fascinated with the topic? Please feel free to share it. We recognize the value of reading our article about Hot Water Heater Repair.

Pro service? Ring!